Specifications

10. If replacing the motor belt, remove the screws securing the motor mount
bracket to the X beam.
11. Carefully slide the motor mount bracket away from the X beam and allow the
drive pulley assembly to separate from the X axis shaft.
12. Replace the motor belt and reassembly the drive pulley assembly to the X axis
shaft and motor mount bracket.
13. Secure the motor mount bracket to the X beam with the original hardware.
14. Orient the new x drive motor into the motor mount bracket with the harnesses
facing toward the X beam PCB.
15. Install the screws to hold the X drive motor to the motor mount bracket, but do
not tighten the screws at this time.
X motor
cover
motor
mount
bracket
X drive
motor
X beam
cable
connection
X beam
PCB
X beam PCB cover
X motor
belt
drive pulley
assembly
motor pulley
x axis shaft
x beam
Figure 2 - 8
X Motor and Belt 2 - 11
110279-01, Rev B 2. Service Maintenance (except head and trimmer)