Specifications

Disk Drive

1. Remove the disk drive panel assembly as previously described.

2. Remove the four screws holding the connectors cover at the rear of the disk drive

assembly (see Figure 2-5) and disconnect the two harnesses from the rear of the

disk drive.

3. The assembly may now be moved to a work surface free of static electricity.

4. Remove the two screws and the two nuts shown in Figure 2-5 that hold the disk

drive top cover and remove the top cover.

5. Remove the four screws that hold the floppy disk drive to the disk drive support

(see Figure 2-5).

6. Replace the disk drive and reassembly the parts in reverse order of the previous

steps.

NOTE: When installing the disk drive data ribbon orient the harness so the edge with

the colored stripe (indicating pin #1) is lying adjacent to the power

harness.

disk drive

panel cover

disk drive

support

connectors

cover

floppy

disk drive

top cover

Figure 2 - 5

2 - 6 Disk Drive

EMT 10/4T Technical Manual Melco Embroidery Systems