Specifications

Disk Drive Panel Assembly
1. To remove the disk drive panel assembly from between the needle cases of the
middle two heads, remove the 2 screws at the front of the panel.
2. Pull down slightly on the panel to remove the pin in the top of the panel from
the grommet in the bottom of the keyboard panel.
3. Disconnect any ground wire attached to the panel.
4. To remove the disk drive panel assembly further the connectors cover of the disk
drive must be removed (see Figure 2-5) and the two harnesses disconnected
from the rear of the disk drive.
Start/Stop Panel Assemblies
1. The start/stop panel assemblies are located between the tensioners of heads #1
and #2 or heads #3 and #4. First remove the lower front cover below the panel
assembly you wish to remove.
2. Remove the two screws holding the panel assembly at the rear tensioner cover.
3. Remove the four screws holding the start/stop panel assembly at the front.
keyboard
panel assembly
Left end
tensioner
cover
right end
tensioner cover
rear
tensioner
cover
start/stop panel
assembly (2 ea)
lower front
cover (2 ea)
disk drive
panel assembly
grabber
cover
pin in top of
lower front
covers and disk
drive panel
Figure 2 - 1
2 - 2 Removing Front Covers, Panels, and Tensioner Covers
EMT 10/4T Technical Manual Melco Embroidery Systems