Specifications

Picker Home Position
Note: This procedure requires the use of a special service tool: the Melco picker
set fixture (p/n 995339-01).
1. Install the picker set fixture (shown in Figure 4-23) to set picker home position.
2. Loosen the set screw inside the swivel pin body shown in Figure 4-22.
3. Move the picker until it rests in the fixture at the picker home position as shown
in Figure 4-23.
4. Retighten the set screw.
Picker Height/Depth Position
Note: This procedure requires the use of a special service tool: the Melco picker set
fixture (p/n 995339-01).
1. To adjust the picker height/depth position, manually push the picker into place as
shown in Figure 4-23.
2. Loosen the 2 screws on the left side of the picker as shown in Figure 4-22.
3. Position the height/depth of the picker against the fixture location and retighten
the 2 screws.
Picker Height/Depth
Position
Picker Home
Position
Picker Fixture
Bobbin End
Front End
Picker Height/Depth Position
Picker Home
Position
Figure 2 - 23
4 - 28 Trimmer Adjustment Procedures
EMT 10/4T Technical Manual Melco Embroidery Systems