Specifications

CAUTION! Be careful not to lose the solenoid return spring in the
next step.
3. At the solenoid plunger, loosen the set screw in the picker swivel clamp and
remove the picker wire from the end of the plunger.
4. Remove the old solenoid wires from the main connector and transfer the new
solenoid wires into the same positions in the connector.
5. Transfer the solenoid return spring from the old solenoid to the new one and
reattach the picker wire at the end of the solenoid plunger.
6. Position the new solenoid in the bracket and secure it with the nut.
7. Reinstall the left rear table top (with optional bobbin winder assembly).
8. Install the rear bed cover and refer to the procedure for adjusting the picker
when you have finished the installation.
Home Position Optical Switch
1. Remove the cap head screw holding the body of the optical switch in position
(see Figure 4-8).
2. Carefully manipulate the switch harness through the cutout in the bracket until
you can access and disconnect the in-line connector.
3. Connect the new optical switch to the in-line connector and place the switch in
position on the bracket.
4. Reconnect the optical switch with the cap head screw.
Picker Assembly
1. Remove the screws holding the needle plate. Remove the needle plate.
2. Disconnect the picker link from the picker base by loosening the set screw inside
the swivel pivot of the picker base (see Figure 4-9).
3. Remove the external retaining ring at right end of the picker base shaft.
4. Slide the picker assembly out of the picker bracket mount.
When re-attaching the picker link to the picker assembly, refer to the alignment
section of this manual for the alignment procedure for the picker position.
Picker Assembly 4 - 9
110279-01, Rev B 4. Trimmer Maintenance