Specifications

Grabber Adjustments
To check grabber blade travel follow these steps:
1. Insure the embroidery heads are synchronized and position them to headup.
2. Turn the machine OFF, and unplug the power cord from the power source.
3. Manually move the grabber motor limit stop lever up to move the grabber blades
all the way out and then down to move the blades back again. (see Figures 4-4
and 4-5).
If you notice any binding in grabber blade movement, find the mechanical bind and
correct it before continuing.
DO NOT USE OIL TO TRY TO CORRECT THE BIND!
top
grabber
blade
cover
grabber
blade guide
front grabber
blade cover
the finger is
pointing to the
grabber blade
Velcro wiper
bar
Figure 4 - 3
4 - 4 Trimmer Replacement Procedures
EMT 10/4T Technical Manual Melco Embroidery Systems