Specifications

Grabber Blade Replacement
1. Remove the 4 screws and take off the top grabber blade cover.
2. Remove the two button head screws that secure the grabber blade to the
grabber drive assembly where it enters into the embroidery head arm casting
(See Figure 4-2).
3. Remove the 4 screws to free the front grabber blade cover (see Figure 4-3). Slide
the grabber blade out of the grabber blade guide (just behind the Velcro wiper
bar) as you remove the cover and grabber blade.
4. Reverse order of the previous steps to replace the grabber blade.
When reinstalling the grabber blade, be sure to slide the grabber blade into the
front blade cover and then the grabber blade guide before installing the screws to
attach the grabber blade to the grabber drive assembly at the entry into the arm
casting.
When tightening the covers, some positioning adjustment may be required to
ensure smooth blade movement.
2 button head
screws securing
grabber blade
Grabber Blade
Figure 4 - 2
Grabber Drive Assembly 4 - 3
110279-01, Rev B 4. Trimmer Maintenance