Specifications

Thread Tree Assembly Removal
If you need to remove the thread tree for any reason, refer to the following
procedure:
1. Turn OFF the EMC 10/4 and disconnect the power cord from its power source.
2. Carefully grasp the thread guide tubes individually and remove them from
behind the thread tensioner assembly by pulling on each thread guide tube (see
Figure 3-18).
3. Remove the 3 screws from each of the four embroidery heads that secure the
thread tree bracket. Two people are recommended in then lifting off the thread
tree assembly.
thread guide tubes
thread tree bracket
thread tensioner
assembly
3 screws
thread tree
Figure 3 - 18
3 - 22 Head Section
EMC 10/4 Technical Manual Melco Embroidery Systems