Specifications

8. Insert the new encoder/shaft into the hole of the encoder mount, place the
washer and then the jam nut onto the encoder shaft as you insert the shaft
through the mounting plate.
9. Insert the encoder shaft into the shaft coupling.
10. Tighten the jam nut, and then snug the coupling socket head cap screws onto
the encoder shaft.
11. Connect the encoder cable to the CPU board.
CAUTION! If the Z shaft encoder is replaced, DO NOT OPERATE THE EMBROIDERY
PERIPHERAL until the new Z shaft encoder is properly calibrated!
12. Calibrate the Z encoder per section 2 of this manual.
Z encoder shaft socket
head cap screws
(1 of 2 shown)
encoder
mount
Jam Nut
Z Encoder Cable
Z Encoder
shaft coupling
Figure 3 - 17
Z Shaft Encoder Installation 3 - 21
110305-01, Rev A 3. Mechanical Disassembly