Specifications

Power Supply Replacement
The power supply is mounted under the top cover between heads #1 and #2. To
remove the power supply assembly:
1. Turn the peripheral OFF and disconnect the power source.
2. Remove top cover #2 between heads #1 and #2.
3. Disconnect the AC and DC wiring (see Figure 3-14).
4. The power supply is attached into self gripping posts at each of the bottom four
corners of the power supply box. Pull up on the power supply with a sharp tug
to release it from the gripping posts and lift it free of the mounting plate.
5. Reattach the new power supply assembly by placing it in position above the self
gripping posts, then pressing downward to engage the posts firmly into the
holes in the power supply.
6. Reattach the AC and DC wiring following the color coded wire information in
Figure 3-14.
7. Power up the machine and check the +5VDC and adjust if necessary. Refer to
the +5 Volt Adjustment in Section 2 of this manual.
self gripping posts
POWER SUPPLY
(Front View)
AC Wiring
DC Wiring
Figure 3 - 14 Power Supply Section
Power Supply Replacement 3 - 17
110305-01, Rev A 3. Mechanical Disassembly