Specifications

2. WAIT ONE
MINUTE, then
remove the cover
over the XYZ
motor driver
section inside the
left frame
support leg (see
Figure 3-12).
3. Disconnect the
harnesses and
remove hardware
associated with
the defective XYZ
motor drive PCB
(see Figure 3-13).
4. Remove the
defective XYZ
motor drive
module.
5. Install the new XYZ motor drive module using the same hardware.
6. Reconnect the harnesses that were disconnected during the removal of the
defective PCB.
7. Reattach the XYZ motor driver section cover removed earlier.
XYZ Motor
Driver Section
(inside left frame
support leg)
Figure 3 - 12
Red to pin 1
White to pin 2
Blue to pin 3
various harness
connections
XYZ motor
drives
Figure 3 - 13 XYZ Motor Drive Section
3 - 16 Under Carriage Section
EMC 10/4 Technical Manual Melco Embroidery Systems