Specifications

4. Remove the two screws, flat washers, and lock washers at the top of the Y-belt

bracket. These screws go through the belt and into the belt clamp underneath

the belt to secure the Y drive belt between the two pieces.

Caution: Overtightening the screws in the next step may cause the belt clamp to be

damaged.

5. Place the new belt around the two pulleys and secure both ends of the belt

between the Y-belt bracket and the belt clamp piece with the two screws and

associated hardware removed in the previous step.

6. Refer to Section 2 of this manual for adjusting the Y drive belt tension.

7. Replace the table covers and test the machine for proper embroidery quality.

screws, and

hardware

attaching

belt to clamp

Belt Clamp

(underneath)

Y Belt

Bracket

Figure 3 - 10

Y Drive Belt Replacement 3 - 13

110305-01, Rev A 3. Mechanical Disassembly