Specifications

7. Lift the x carriage and y beam off the 3 supports and lay it up side down across
the 2 end table top sections.
8. Remove the socket head cap screw and 2 phillips head screws at the remaining x
drive belt clamp.
9. Remove the x drive belt clamp from ONLY ONE END of the old belt. Leaving one
clamp on the old belt will provide you with a guide to work from when
installing the first clamp on the new belt.
10. Tape the new x drive belt to the unclamped end of the old belt and pull the new
belt into place around the spline shaft pulley and idler rollers. Remove the old
belt from the new belt.
11. Using the remaining clamp on the old belt as a guide and referring to Figure
3-8, perform the following procedure to attach the clamp removed from the
old belt to one end of the new belt.
a) Orient the clamp with the cutout for the belt in the small edge facing you.
b) With the smooth side of one end of the new belt facing the cutout, slide
that end of the belt into the slot in the clamp. The belt teeth will be
facing toward the threaded through hole.
c) Position the belt through the clamp far enough to insert the retaining pin
into the fold at the end of the belt (see Figure 3-8, A).
d) While holding the pin is place, pull the belt back through the clamp until
the pin is captured in the pin cutouts on the clamp (see Figure 3-8, B).
x drive
belt
clamp
x drive
belt
threaded
through
hole
retaining
pin
BA
Figure 3 - 8
X Drive Belt Replacement 3 - 11
110305-01, Rev A 3. Mechanical Disassembly