Specifications

Carriage Section
This assembly and its installation to the peripheral requires specific factory tooling
and training to maintain the assembly’s parallelism with the rest of the peripheral.
Portions of the carriage assembly may be disassembled to replace various parts
without sacrificing the overall orthogonal integrity.
X Drive Belt Replacement
"FACTORY SERVICE ADVISED"
NOTE 1: The carriage assembly must be partially removed to replace the x carriage
drive belt.
NOTE 2: Be advised that a special quick-drying adhesive is required to complete this
procedure.
1. Turn OFF the embroidery peripheral and unplug the power cord.
2. Remove the table top inserts and the middle table top section.
3. Position the y beam to mid-range of the y axis movement. Position the x carriage
slightly left or right of mid-range of the x axis movement.
4. From under the carriage assembly, remove the socket head cap screw that
tensions the belt at the end of the clamp on one end of the belt (see Figure 3-7).
5. Next, remove the 2 phillips head screws that secure the x drive belt clamp to the
x carriage at the same end as in the previous step.
6. Remove the 4 socket head cap screws from the top of the beam at each of the 2
end and one middle support. (This step involves the removal of 12 socket head
cap screws in all.)
socket head
cap screw
Left X
carriage
section
X carriage belt
phillips head
screw (2 ea)
belt clamp
Figure 3 - 7
3 - 10 Carriage Section
EMC 10/4 Technical Manual Melco Embroidery Systems