Specifications

7. Refer to Figure 3-6 inset and remove the zener diode assembly ring terminal
from the top of the #2 head needle case.
8. Remove the 4 screws holding the keyboard cover to the tensioner brackets of the
2 middle embroidery heads and remove the keyboard and cover to a surface
which is free of static electricity.
9. Remove the keyboard/display assembly from the cover by removing the 4 screws
securing the PCB to the standoffs in the cover.
10. Transfer the key caps from the old keyboard PCB to the new keyboard PCB by
simply lifting them off of the keys by using finger pressure only. It is
recommended that this be done one key at a time to avoid errors in key cap
arrangement on the new keyboard PCB.
11. When the key caps are transferred, reinstall the keyboard/display assembly by
reversing the preceding steps.
Refer to the Adjustment Section of this manual for information in adjusting the
intensity of the display, if required.
zener diode
assembly from
keyboard PCB
standoff
(1 of 4)
Keyboard
Assembly
attaching screw
and hardware
(1 of 4)
Keyboard
Cover
ground wire to
the bottom of
keyboard cover
Figure 3 - 6
Keyboard/Display Replacement 3 - 9
110305-01, Rev A 3. Mechanical Disassembly