Specifications

2. To remove any or all of the lower front covers (between needle cases), remove
the 2 screws (c) for each cover. Pull down slightly on the cover to remove the
pin in the top of the cover from the grommet in the bottom of the upper front
cover (between the tensioner brackets), then carefully remove the lower front
cover from the area.
3. To remove the upper front covers or the keyboard and cover from between the
tensioner brackets, you must first remove the lower front cover associated with
the upper front cover you wish to remove. Next, disconnect all associated
harness connections with the cover you are removing. Then, remove the screws
(b) and screws (d) associated with the upper front cover and remove the cover
carefully. Use care not to damage any components or cables.
4. To remove the left end tensioner cover, loosen the 2 screws (a) and remove the 3
screws (e). Slide the cover to the left slightly to remove it from the loosened
screws (a) and carefully remove the cover.
5. To remove the right end tensioner cover, remove the 1 screw (b) holding the rear
tensioner cover and remove the 3 screws (f). Remove the right end tensioner
cover carefully.
3 - 4 Embroidery Peripheral
EMC 10/4 Technical Manual Melco Embroidery Systems