Specifications

To Adjust For A:
1. Position the grabber blades as far back as they will go into the grabber blade
guides by manually moving the motor limit stop lever down as shown in Figure
2-39.
2. Locate the socket head cap screw in the end of the grabber blade guide (see
Figure 2-50).
3. Loosen the cap screw and move the guide until the grabber blade is directed
toward the middle of the Velcro wiper bar.
4. Tighten the socket head cap screw in the grabber blade guide.
To Adjust For B:
The grabber blade travel is adjusted at the wire swivel where the transition bracket
and guide rod enter into the rear of the head. From the transition bracket, the rod
is inserted into the wire swivel and held in place with a set screw.
1. Position the grabber blades as far back as they will go into the grabber blade
guides by manually moving the motor limit stop lever down as shown in Figure
2-39.
2. Find the small set screw at the right side of the wire swivel in the grabber blade
transition bracket (see Figure 2-51).
3. Loosen the set screw in the wire swivel and position the grabber blade so the
hook is protruding between 1.5 and 2.5 mm (.060 - .100 inches) from the
guide (see the inset in Figure 2-50).
grabber
blade
guide
socket
head cap
screw
1 1/2 to
2 1/2 mm
(.060 - .100
inches)
Grabber
Blade
Guide
grabber
blade
hook
portion
Velcro
Wiper Bar
grabber blade
hook portion
FRONT VIEW
Figure 2 - 40
Trimmer Option 2 - 47
110305-01, Rev A 2. Service Adjustments