Specifications

1. To adjust the picker height/depth position, manually push the picker into place as
shown in Figure 2-37.
2. Loosen the 2 screws on the left side of the picker as shown in Figure 2-36.
3. Position the height of the picker against the fixture location shown in Figure 2-37.
4. Retighten the 2 screws.
5. Loosen the hex nut which is locking the socket head cap screw under the picker
base as shown in Figure 2-37.
6. While still holding the picker in the height/depth position, rotate the socket head
cap screw until the depth position is attained as shown in Figure 2-37.
7. Retighten the hex nut, locking the socket head cap screw to hold the depth
position setting.
Grabber Adjustments
To check grabber blade travel follow these steps:
1. Insure the embroidery heads are synchronized and position them to headup.
2. Turn the machine OFF, and unplug the power cord from the power source.
socket head cap screw
locking
hex nut
Picker Depth Position
Picker Home
Position
Picker Height
Position
Figure 2 - 37
Picker Fixture
Bobbin End
Front End
Picker
Depth
Picker
Home
Picker Height
Trimmer Option 2 - 45
110305-01, Rev A 2. Service Adjustments