Specifications

2b. With both trimmers and cap frame options on the machine, move the bracket to

center the installed cap frame driver on the embroidery head arm.

3. Retighten the screws.

Picker Home Position

Note: This procedure requires the use of a special service tool: the Melco picker

set fixture (p/n 995339-01).

1. Install the picker set fixture (as shown in Figure 2-37) to set the picker home

position.

2. Loosen the set screw inside the swivel pin body shown in Figure 2-36.

3. Move the picker until it rests in the fixture at the picker home position as shown

in Figure 2-37.

4. Retighten the set screw.

Picker Height/Depth Position

Note: This procedure requires the use of a special service tool: the Melco picker set

fixture (p/n 995339-01).

Front View

The Picker

should be

centered on

the Bobbin

Shaft.

Dovetail

clamp

Figure 2 - 36

Picker Height

Adjustment

Screws

Adjust Picker Home Position

here (locking set screw inside

swivel pin body)

Picker/dovetail bracket attachment screws (side to side picker

assembly positioning is made by loosening these 2 screws.)

Left Side View

Dovetail

clamp

2 - 44 Head Section

EMC 10/4 Technical Manual Melco Embroidery Systems