Specifications

4. Go to the TRIM MENU and perform a TRIM IMMEDIATE command.
5. The movable knife should be located under the spring knife, positioned as shown
in Figure 2-32. If the sloped rear tip of the movable knife is not showing in
front of the leading edge of the spring knife, the "home" position needs to be
adjusted.
DO NOT Adjust if the knife position looks like Figure 2-32.
6. To adjust movable knife home position, loosen the two screws at the connecting
link drive block in the camming section of the trimmer system (see Figure 2-33).
7. By moving the movable knife, position it to the described home position,
allowing the connecting link block to reposition on the camming frame.
8. Snug the two connecting link block screws.
WARNING! Keep clear of the moving parts that are exposed during the operation
of the next step(s).
9. Perform a TRIM IMMEDIATE command again and check for the correct home
position.
10. Repeat steps 7, 8, and 9 until the movable knife home position is correct.
11. Tighten the two connecting link block screws when the home position is
adjusted correctly.
Movable Knife
Spring Knife
The part of the rear tip
of the movable knife
that slopes away from
the top surface is
showing in front of the
leading edge of the
spring knife.
Figure 2 - 32 Movable Knife Home Position
Trimmer Option 2 - 39
110305-01, Rev A 2. Service Adjustments