Specifications

7. With the carriage still centered, attach the X-Belt Fixture (p/n 995509-01) onto
the x carriage belt, centered between the spline drive pulley and one of the end
clamps as shown in Figure 2-5.
8. When properly tensioned, the fixture hanging arm will
just be touching the
under side of the carriage foam. If it is touching when first installed, you must
loosen the belt enough to see clearance between the hanging arm and the
foam and then re-tension.
9. At the end of the X carriage belt with the largest gap between the socket head
cap screw mount and the belt clamp, turn the socket head cap screw clockwise
to tighten the belt.
NOTE: When tightening the belt tension you will want to tighten evenly at the each
end to maintain nearly even gaps between the clamps and the mounts.
10. Continue to tighten the socket head cap screw until the fixture hanging arm
just
touches the under side of the carriage foam.
11. Remove the fixture and tighten the 2 phillips head screws that secure the X
carriage belt clamps to the X carriage at both ends of the X carriage belt.
12. Reattach the middle table top section and the table top inserts.
socket head
cap screw
Left X
carriage
section
X carriage belt
phillips head
screw (2 ea)
belt clamp
Figure 2 - 4
phillips screws
X carriage belt
socket head
cap screw
X-Belt Fixture
(995509-01)
threaded
insert
embroidery
head bed
Figure 2 - 5
2 - 6 Carriage Section
EMC 10/4 Technical Manual Melco Embroidery Systems