Specifications

5. Position the X carriage left/right movement to center the cap frame driver hoop
notch directly over the cylinder arm cover of the embroidery head as shown in
Figure 2-2. (If no cap frame driver, center the hoop attaching mechanism over
the cylinder arm as best as you can determine.)
6. Loosen the 2 phillips screws at each X carriage belt clamp (see Figure 2-5). By
rotating the socket head cap screws counter-clockwise evenly at the ends of
both clamps, loosen the X carriage belt enough to allow it to slip around the
spline shaft pulley.
7. Rotate the spline shaft (allowing the X carriage belt to slip around the pulley)
until the front disk is centered (or very nearly centered) at the bottom of the
front support bracket as Figure 2-3 shows.
8. By rotating the socket head cap screws clockwise evenly at the ends of both
clamps, tighten the X carriage belt enough to keep it from slipping during the
remainder of this procedure.
9. Insure the cap frame driver hoop notch is still directly over the cylinder arm cover
when the front disk is centered at the bottom of the front support bracket and
remove the cap frame driver.
Cap Frame
Driver
Cap Frame
Guide to
Arm Cover
centerline
Arm
Cover
Cap
Frame
Guide
Needle Plate
Figure 2 - 2
2 - 4 Carriage Section
EMC 10/4 Technical Manual Melco Embroidery Systems