Specifications

The peripheral will now be in the ‘‘configuration mode,’’ and you can release the 3
keys.
NOTE: If the unit is already ON, but has not yet "downloaded," you need only to
depress and hold the 3 peripheral keyboard keys until the unit beeps to
get into the configuration mode, then proceed. You do not need to turn
the EMC 10/4 OFF, then ON again.
When the EMC 10/4 is in the ‘‘configuration mode,’’ you can set (or change) the
Peripheral Program, Unit Number, and Display language for the machine.
Peripheral
Program
5. To set the Peripheral Program, simply depress the or keys on the
peripheral keyboard until the correct program shows on the display. The
programs specific to the EMC 10/4 are: EMC 10/4, (without trimmers), or EMC
10/4T (with the trimmer option). After getting the proper program name
showing on the display, depress the key on the peripheral keyboard to
"set" the program.
Unit Number 6. After the key is depressed the configuration item will go to the Unit Number
selection. To select a Unit Number, again simply depress the or keys
on the peripheral keyboard until the desired Unit Number shows on the display.
(You cannot have two peripherals with the same Unit Number attached to an
EDS operating system.) After the desired number is showing on the display,
depress the key on the keyboard.
Display
Language
7. The last item you may select in the configuration mode is the language used for
showing the information in the display. Again, depress the or keys on
the peripheral keyboard until English or Spanish appears on the display.
8. After the desired language is showing on the display, depress the key on
the peripheral keyboard.
The EMC 10/4 configuration is now complete.
Configuring the EMC 10/4 1 - 7
110305-01, Rev A 1. Introduction