Specifications

Movable Knife Drive Arm
1. Remove the screws holding the needle plate. Remove the needle plate.
2. Remove the screws holding the front and rear bed covers. Remove the covers.
3. Lift the forward end of the connecting link from the pin on the movable knife
drive arm (see Figure 3-45).
4. Remove the small pan head screw and fixing clip from the bottom of the needle
plate bracket.
The clip is held into a slot in the arm shaft by the screw and the combination holds
the arm shaft in place. Once this clip is removed, the arm shaft is free to be remove
out of the top of the needle plate bracket.
small pan
head screw
fixing clip
Connecting Link
Needle Plate
Bracket
Movable Knife
drive arm
Figure 3 - 45
Trimmer Assemblies 3 - 53
110305-01, Rev A 3. Mechanical Disassembly