Specifications

5. Loosen the hex nut between the the solenoid body and the mount, then rotate
the solenoid assembly out of the mount.
6. Rotate a new solenoid assembly into the mount. Do not tighten the hex nut or
set screw in the top of the mount at this time.
7. Reinstall the solenoid and mount to the movable frame and refer to the
adjustments section of this manual to adjust for solenoid positioning and
movable knife home position. When the trimmer solenoid and mount are
reinstalled you may also need to adjust the home stop screw or adjust the
solenoid mount to achieve proper travel of the solenoid pin into the cam groove.
8. Reinstall the head rear bed cover.
Picker Solenoid Assembly
FACTORY SERVICE ADVISED!
This assembly is mounted at the rear of the trimmer drive assembly in the rear bed
of the embroidery head. To remove the solenoid requires among its steps, the
removal of the trimmer drive assembly from the embroidery head.
1. Remove the head rear bed cover to gain access to the trimmer drive assembly.
2. Refer to Figure 3-44 and remove the cap head screw holding the movable knife
connecting link to the drive block.
3. Remove the four hex bolts holding the trimmer drive assembly into the bed of the
embroidery head. Allow the assembly to be lowered from the bottom of the bed.
4. Disconnect the picker link from the picker solenoid plunger by removing the set
screw and swivel clamp that hold them together.
5. Disconnect the home position optical switch and trimmer solenoid in-line
connectors from the picker solenoid harnessing.
6. Loosen the hex nut that snugs the solenoid to the mounting bracket. Rotate the
solenoid out of the mounting bracket.
7. Reverse the previous procedure to install a new picker solenoid.
8. Refer to Section 2 of this manual for checking and performing the various picker
adjustments.
Trimmer Assemblies 3 - 49
110305-01, Rev A 3. Mechanical Disassembly