Specifications

5. Lay the color change mount key into the embroidery head key way, then put the
new color change bracket (with the cam) into position.
6. Ensure the needle case is positioned with the needle centered in the needle plate
hole by moving the color change bracket to obtain the needle centering, then
tighten the color change bracket screws. Check and center (if needed) the other
heads by adjusting the needle case linkage shafts between the various needle
cases.
7. Reinstall the color change motor and color change PCB as previously described
and reattach the color change area cover behind the tensioner assembly.
Trimmer Assemblies
The thread trimmer assemblies lie in three general areas of the head: in and about
the hook and bobbin area, on the arm casting behind the front of the head, and in
and throughout the cylinder bed. Replacement procedures for these various parts
are found in this section.
Grabber Drive Assembly
FACTORY SERVICE ADVISED!
The grabber drive assembly is mounted to the left side of the # 2 embroidery head
arm casting (see Figure 3-39). A factory trained technician is recommended for
removing and installing parts in this section.
color change
bracket (with cam)
2 color change
bracket screws
color change
mount key
Figure 3 - 38
Trimmer Assemblies 3 - 45
110305-01, Rev A 3. Mechanical Disassembly