User manual

7
1. The remote control only turns on and of f the Docking Base. The left and right satellite
speakers must be turned on/of f manually usi ng the power switc h located on back of
each speaker box.
2. The volume of satellite speakers are default set to maximum when the speaker power
is on.
PLAYING MUSIC FROM YOUR COMPUTER
To play music from a Windows or Mac OS X based personal computers.
NOTE:
1. The volume of satellite speakers are default set to maximum when the speaker power is on.
2. When you playing music from your computer, the volume control on Docking Base and remote
control will not work. Please use the volume control on your computer or the volume buttons on the
wireless speakers to control the sound level.
Windows Based Computer (for Windows 2000/XP or above)
1.) Remove the USB Transmitter from the back of the Docking Base and plug it into the USB port of
your computer. The computer reports “Found New Hardware” the first time the USB port is
accessed. Wait for the computer to automatically search and install the necessary device drivers
for the USB Transmitter. Once installed, the PC will show “Your new hardware is installed and
ready to use” when the device drivers have been properly installed.
2.) Go to your computer control panel and set the default audio sound playback device to the “SYNIC
Wireless Audio”.
3.) Fully charge and place the two speakers within wireless range of the transmitter that is plugged
into the USB port of your computer.
4). Link the wireless speakers by following linking instructions mentioned in the “Getting Start” section
of the manual. Now you can play music from your PC and listen to it through your wireless speaker
system.
5.) Open the music player program on your computer, and adjust the volume of the player program to
a low level.
6). Click the play button, and slowly increase the volume level of your player program to adjust the
sound level.
7). Press the Volume+/- button on speaker boxes to control the sound level if necessary.
Mac Based Computer (for Mac OS X)
1.) Remove the USB Transmitter from the back of the Docking Base and plug it into the USB port of
your Mac.
2.) Go to your computer system preferences and set sound output to “SYNIC Wireless Audio” USB
device
3.) Fully charge and place the two speakers within wireless range of the transmitter that is plugged
into the USB port of your computer.
4.) Link the wireless speakers by following linking instructions mentioned in the “Getting Start” section