User's Guide
Table Of Contents
- 1. Safety Instructions
- 2. Getting Started
- 2.1 Connecting Baby Unit to power
- 2.2 Installing the battery and connecting Parent Unit to power
- 2.3 Desktop Mount of Parent Unit
- 3. Using Your Baby Monitor
- 3.1 Power on or off the Baby Unit
- 3.2 Power on or off the Parent Unit
- 3.3 Turn off the Parent Unit screen
- 3.4 Adjust the speaker volume for Parent Unit
- 3.5 Adjust the LCD brightness of the Parent Unit
- 3.6 Set the alarm on the Parent Unit
- 3.7 Monitor the temperature
- 3.7.1 Temperature format
- 3.8 Delete a Baby Unit
- 3.9 Set the screen off time of the Parent Unit
- 3.10 Zoom
- 3.11 Pair and replace extra new Baby Unit
- 4. Disposal of the Device (environment)
- 5. Cleaning
- 6. Troubleshooting
- 7. General Information
Getting Started 11
2.2 Installing the battery and connecting Parent Unit to
power
A rechargeable battery pack is supplied and should be fitted, so that the Parent
Unit can be moved without losing the link and picture from the Baby Unit(s).
Charge the Parent Unit before you use it for the first time or when the Parent Unit
indicates that the battery is low.
1. Slide off the battery compartment cover
2. Insert the plug of the battery pack into the jack inside the battery
compartment, and fit the battery pack into the compartment.
3. Replace the battery compartment cover, and pull out the stand (refer to
section 2.3).
4. Insert the DC plug of the power adaptor with the bigger DC plug into the
DC jack in the side of the Parent Unit.