User's Guide
Table Of Contents
- 1. Getting started
- 2. Getting to know your phone
- 3. Using the phone
- 4. Contacts
- 5. Clock and alarm
- 6. Call control
- 6.1 Call barring
- 6.2 Call block
- 6.2.1 Block all international calls
- 6.2.2 Block all private calls
- 6.2.3 Block all unavailable calls
- 6.2.4 Block all payphone calls
- 6.2.5 Turn call block on / off
- 6.2.6 Add a number to the call block list
- 6.2.7 Edit a number in the call block list
- 6.2.8 Delete a number from the call block list
- 6.2.9 Delete the blocked list
- 7. Caller ID and calls list
- 8. Handset settings
- 9. Advanced settings
- 10. Registration
- 11. Software version
- 12. Using your Answering Machine
- 12.1 Switch the answering machine on / off
- 12.2 Listening to messages
- 12.3 Adjust the speaker volume
- 12.4 Delete messages
- 12.5 Announcement
- 12.6 Record a memo
- 12.7 Answer settings
- 12.8 Remote access
- 12.9 Remote access on/off and setting the remote access PIN
- 12.10 Change the remote access PIN
- 12.11 Memory full
- 13. Help
- 14. Technical Specifications
- 15. General information
52
Help
13. Help
The icon is not scrolling during charge
• Bad battery contact – move the handset slightly.
• Dirty contact – Clean the battery contact with a cloth moistened with
alcohol.
• Battery is full – no need to charge.
No dialing tone
• No power – check the connections. Reset the phone: unplug and plug back
in the mains.
• Batteries are empty – charge the batteries for at least 16 hours.
• You are too far from the base – move closer to the base.
• Wrong line cable – use the line cable provided.
• Line adaptor (when needed) is not connected to the line cord – connect
the line adaptor (when needed) to the line cord.
Poor audio quality
• The base is too close to electrical appliances, reinforced concrete walls
or metal doorframes – move the base at least one metre away from any
electrical appliances.
The
icon is displayed with no bars
• Handset is not registered to the base – register the handset to the base.
• You are too far from the base – move closer to the base.
No ring tone
• The ring tone is deactivated.
• Increase the volume.
• Make sure the Call Block mode is switched to o.
Caller ID service does not work
• Check your subscription with your network operator.
A contacts entry cannot be stored
• The contacts is full. Delete an entry to free memory.
No display
• Try recharging the batteries.
• Try disconnecting and connecting the base power supply.
• If LED is not lit up, then try disconnecting and connecting the base power
supply.
Unable to register another handset
• Maximum number of 4 handsets has been reached.
• You must deregister a handset in order to register a new one.
Noise interference on your radio or television
• Your base or charger may be too close. Move it as far away as possible.