Specifications

The MPAC-110 Power Supply receptacle fuse rating is 6.3 Amps 250 Volts slo blo.
The MPAC-220 Power Supply fuse rating is 3.15 Amps 250 Volt slo blo.
CAUTION: For continued protection against the risk of re, replace only with the same type and rating of fuse.
Power Supply Removal: Power (AC or DC) should be disconnected from the module before removing for replacement or
service. This is accomplished by removing the AC IEC plug for the MPAC unit and the terminal block for the MPDC unit. To
remove a power supply module from the chassis, gently lift the front handle and pull back on the module until it is clear of
the chassis guide slot.
ERRATA (14 May 2008)
The Optical Transmitter modules MPTXxxx referenced in this manual for use in the MP3xxx Chassis are pending acceptance
by UL.
CHAPTER 8: SERVICE & SUPPORT
8-2 MAXNET
®
II – MP3 Active / Passive Chassis – Installation & Operation Manual