Technical information

Quick Start
When booting the system the following message will be displayed while dots will
be counted up in the lower line:.
Main Menu will be displayed with some important status informations after booting
has finished:
If the GPS receiver remains asynchronous (Refclock LED is still red after 12 minutes)
the number of satellites in view and the good satellites are to check (press bottons
„i,ok,i,ok,g,ok“ from main menu). The antenna has to be installed without any
obstructions to the sky.
For first time installation enter TCP/IP address, netmask and default gateway. To get
an overview of the current configuration press F2 from main menu. Press F2 again to
enter SETUP configuration page. Please ask your administrator for propper TCP/IP
configuration:
Then press 3 times the OK button to change to IPV4 ETH0 configuration page to
enter the IP address, netmask and the default gateway:
NOTE: These settings are related to the first Ethernet connection (ETH0).
After this all further settings can be done via network interface, either by using a
WEB browser or a Telnet Session.
Default user: root
Default password: timeserver
8
GPS: NORMAL OPERATION Mon, 28.08.2006
NTP: Offset PPS: -50us UTC 14:33:10
SATELLITE CONSTELLATION
In view: 8 Good: 8 Sel: 05 17 04 22
SETUP: Ipv4 LAN Parameter ETH0
Ipv4 ADDRESS: 192.168.10.200
MEINBERG TIMESERVER please wait...
.......
Global Cfg. Services
-> Interfaces <-