Technical information

Menu: Setup Ipv6 Parameter
The IPv6 parameters can be configured via the front panel display for the first
ethernet port (ETH0) only. Additional IPv6 configuration can be done via network
connection with TELNET, SSH or the WEB interface.
You can specify up to three IPv6 addresses for your LANTIME timeserver (two via
front panel display and another one via WEB interface). Additionally you can switch
off the IPv6 autoconf feature. IPv6 addresses are 128 bits in length and written as a
chain of 16 bit numbers in hexadecimal notation, separated with colons. A sequence
of zeros can be substituted with “::” once.
If you enabled the IPv6 protocol, the LANTIME always gets a link local address in
the format “fe80:: ….”, which is based upon the MAC address of the interface. If a
IPv6 router advertiser is available in your network and if you enabled the IPv6
autoconf feature, your LANTIME will be set up with up to three link global addresses
automatically.
Menu: Link Mode
The parameters for speed and link mode of the net card can be changed with the
menu item „Link Mode“. There are 5 modes available: Autosensing, 10 MBit/Half-
Duplex, 100 MBit/Half-Duplex, 10 MBit/Full-Duplex, 100 MBit/Full-Duplex.
Default setting is Autosensing.
41
OK
-> Link Local <- glob.Addr 1
Auto Config. glob Addr 2
Ipv4 Parameter Link Mode
-> Ipv6 Parameter <-
SETUP: ETH0 Device Parameter
Link Speed/Mode: Autosensing