Technical information

Serial Outputs

This menu lets the user configure the baud rate and the framing of the serial RS232

port to one of the following values:

Baudrate: 300 bis 19200

Datenformat: 7E2, 8N1, 8E1, 8O1

COM provides a time string once per second, once per minute or on request. If the

„on request“ is activated you have to send the character „?“ to get the timestring.

Defaulteinstellung: COM: 19200 baud, 8N1, per second

This topic is used to select one of several different types of serial time strings or the

capture string for each serial port.

The following time strings can be selected. All time strings are described in the

appendix at the end of this documentation.

- Standard Meinberg-Telegramm

- GPS Capture-Telegramm

- SAT-Telegramm

- UNI-Erlangen-Telegramm

- NMEA-Telegramm (RMC)

- SPA-Telegramm

- Computime-Telegramm

- Sysplex1-Telegramm

RACAL-Telegramm

Setup Time Zone of Serial Outputs

The time zone of the GPS receiver can be set up. These parameters will affect the

serial output lines and the time code (IRIG) outputs. The internal time zone of the

timeserver and the time of NTP will always be UTC. The time monitored in the main

menu will be the time of the NTP.

This menu lets the user enter the names of the local time zone with daylight saving

disabled and enabled, together with the zones´ time offsets from UTC. The left part of

->Setup COM 0 <- Setup Time Zone

Setup COM 1

Serial Port Parameter

Speed, Framing, Mode, Type