Technical information

GPS Satellite Constallation
The SV constellation menu gives an overview of the current satellites (SVs) in
view. The display shows the number of satellites with an elevation of 5° or more (In
view), the number of satellites that can be used for navigation (Good) and the selected
set of satellites which are used to update the receiver position (Sel).
Setup GPS Outputs
GPS Enable Outputs
This menu lets the user configure at which time after power up the serial ports,
pulse outputs, and frequency synthesizer output are to be enabled. Outputs which are
shown to be enabled always will be enabled immediately after power-up. Outputs
which are shown to be enabled if sync will be enabled after the receiver has decoded
the signals from the satellites and has checked or corrected its on-board clock. The
default setting for all outputs is if sync.
29
SATELLITE CONSTELLATION
In view: 8 Good: 7 Sel: 05 22 17 09
Setup GPS -> Setup Outputs <-
Info GPS
OK
->Enable Outputs<- Serial Outputs
IRIG Output Pulse Outputs
Enable Outputs
Pulses: always Serial: always