Technical information

Init GPS Receiver
Initiate Cold Boot of GPS Receiver
This menu lets the user initialize all GPS data’s, e.g. all saved satellite data will be
cleared. The user has to acknowledge this menu again before the initialization starts.
The system starts operating in the COLD BOOT mode and seeks for a satellite to read
its actual parameters.
Initiate Warm Boot of GPS Receiver
This menu lets the user force the receiver into the Boot Mode. This may be
necessary when the satellite data in the memory are too old or the receiver position
has changed by some hundred kilometers since last operation. Synchronization time
may be reduced significantly. If there is valid satellite data in the memory the system
starts in the WARM BOOT mode, otherwise the system changes into COLD BOOT
to read new data.
26
OK
->GPS Cold Boot<- Init GPS Position
GPS Warm Boot Init GPS Time
Setup GPS Receiver Parameters
-> Init GPS Receiver <-
Initiate WARM Boot of GPS receiver
Press F2 to confirm
Initiate COLD BOOT of GPS receiver
Press F2 to confirm