User`s guide

77
A051193
Fig. 3.1.1.-2 Open the tool from the Object Navigator dialog
When Application Object Export/Import Tool is started from the Object Navigator
menu item by selecting Data > Import . See 3.1.1.-2. In this case, the tool is started
on import mode, i.e. it can only be used for importing the application objects. When
the import operation is finished, the selected Object Navigator view becomes
updated.
Close the Export & Import Tool by clicking the Close button. The tool can also be
closed by selecting Object > Exit or by the keystroke Alt+F4. See Fig. 3.1.2.-1.
3.1.2. Exporting objects
Use common options to define the set of application objects to be exported. The
application objects that match the common options are listed in the Application
Objects tabbed page. Select the application objects that need to be exported. When
Select All is clicked, all the objects are selected. When Unselect All is clicked, none
of the objects are selected. To select separate application objects from the list, hold
the Ctrl key down while clicking the objects.
When the selection contains at least one application object, Export is enabled.
When the button is clicked, a destination (export) file is created. See Fig. 3.1.2.-1.
When Export All is clicked, all objects are exported without selecting any objects.
The Application Objects tabbed page shows only the first 10 000 objects in the list.
The button also exports the objects that are not shown in the tabbed page.
MicroSCADA Pro
Installation and Administration Manual
SYS 600 9.2SYS 600 9.2
1MRS756115