User`s guide

TT "LOCAL"
ND The node number of the NET unit to which the printer is
directly connected
TN The device number of the printer in the NET unit to which it
is directly connected
DT "COLOR", "NORMAL", or "TRANSPARENT". Select
"NORMAL", if the printer will be used exclusively for the
black-and-white character-based printout. Select
"COLOR" for all other types of picture-based printout. Even
the printer will be black-and-white, "COLOR" is preferable
as this mode provides a more picture resembling printout
by exchanging graphical characters to printer specific
characters. Select "TRANSPARENT", if the printout will be
SCIL defined.
DC "NET"
In addition, optional features are defined by the following attributes:
LP Lines per page
QM Queue length maximum
OD Output destination: "PRINTER", "LOG" (disk files) or
"BOTH"
LD, LL, LF Printer log attributes, specially the management of log
files. The attributes are meaningful, if OD = "LOG" or
"BOTH"
2. If needed, map the printer for an application with the APLn:BPR attribute,
("Device Mapping"). The printer mapping is required only if you want to use a
logical printer number which is not the same as the printer object number.
Include the following definitions in the NET unit to which the printer is directly
connected:
1. Select a line for the printer and define the line with the ASCII protocol:
PO 4
IU 1
LT 0
MS, MI System message handling, see chapter 17
PS Buffer pull size, see
BR Baud rate (recommended value 2400)
PY 0
RD 8
SB 1
TD 8
OS Output synchronization, refer to the system objects
manual, chapter 13
2. Define a printer (a PRI object) on the selected printer line with the attributes:
70
SYS 600 9.2SYS 600 9.2
MicroSCADA Pro
Installation and Administration Manual
1MRS756115