User`s guide

A070551
Fig. 2.5.2.-11 FrameWindow MicroSCADA
To open a FrameWindow MicroSCADA picture select “SER1 SYS600 Pro
Monitor”
2.6. Installing process communication units
2.6.1. PC-NET process communication unit
The PC-NET process communication unit is a Windows executable which is
automatically installed when the SYS 600 packet is installed or upgraded. The
instances of these units are defined with the system configuration tool, see System
Configuration manual, chapter ‘Configuring process communication’. In runtime,
each configured NET in the system configuration will have a corresponding
pc_nets.exe process running.
Depending on configuration, the communication lines configured to PC-NET
instances will use serial ports, network adapters or PCLTA extension cards (LON
communication). The required hardware must be installed and configured before a
complete verification of the system configuration can be done.
The installation of the computer hardware used by PC-NET process communication
units is described in Section 2.6.1.1. Installing multiport serial card, Section 2.6.1.2.
Installing LON cards, Section 2.6.1.3. Installing network cards and Section 2.6.1.4.
Verifying PC-NET process communication unit.
2.6.1.1. Installing multip ort serial card
Each PC-NET instance supports 12 communication lines and in most cases,
additional COM ports are required. The usage of standard COM ports 1-4 is also
possible.
64
SYS 600 9.2SYS 600 9.2
MicroSCADA Pro
Installation and Administration Manual
1MRS756115