User`s guide

MicroSCADA Pro must be installed on a disk drive physically located

in the base system computer. It cannot be installed on a logical disk

drive, for example a network drive.

6. After selecting the components to be installed, click Start. If a previous

installation of the selected software package is detected, a System Information

dialog is shown.

7. After the System Base Software has been installed, type a password for a

MicroSCADA user, see Fig. 2.1.4.-3. The MicroSCADA user is created during

the installation. It belongs to the Administrator group and it is the user who owns

the MicroSCADA processes.

The MicroSCADA user performs all references made by the processes. If two

base system computers share resources, the MicroSCADA user should be given

the same password on both computers. The password can be changed later from

the MicroSCADA Pro Control Panel.

This user name should not be used for purposes other than

administration tasks. If the MicroSCADA user already exists due to a

previous installation, the password is not changed.

A051498

Fig. 2.1.4.-3 MicroSCADA User Password dialog

8. After base software is installed, other selected packages are installed.

9. The installation completed dialog is shown when MicroSCADA Pro has been

installed.

Installing COM 500i

Existing product COM 500 is included in SYS 600 9.2 or newer as a functionality

- COM 500

i that is license dependent. COM 500i is a communication gateway

running on a MicroSCADA Pro platform. It provides a gateway between process

devices and eight Network Control Centers (NCC). The main tasks of COM 500

i are

signal rerouting and protocol conversions. A COM 500

i tab is constructed, when the

SYS 600 is started for the first time. Select the COM 500

i tab from the Tool manager

to use the COM 500

i functions, see Fig. 2.1.4.-4.

MicroSCADA Pro

Installation and Administration Manual

SYS 600 9.2SYS 600 9.2

1MRS756115