User`s guide

155
PQ = 16,- ;Number of parallel queues/ Needed in COM 500 Applications
QD = (1,1,0,0,0,0,1,1,1,1,1,1,1,1,1,1),- ;Parallel queue dedication/ Needed in
COM 500 Applications
If any project specific modifications have been made to the command procedures of
the previous COM 500 revision, the modifications must be copied to the matching
new command procedures. A back-up of the project specific modifications must be
taken before installation of COM 500
i, because all command procedures are updated
during COM 500
i start-up.
Base System, LIB 5xx and Communication unit changes are described in
Section 4.1. Base system, Section 4.2. LIB 5xx, and Section 4.4. Communication
units. The same changes should be also made when COM 500 is updated to
COM 500
i. Corresponding of COM 500 and SYS revisions are show in the
following table:
Table 4.5.1.-1 Correspondence of COM 500 and SYS revisions
COM 500 revision SYS revision
4.2.SP2 SYS 600 9.1.5
4.2 SP1 SYS 600 9.1 SP1
4.2 SYS 600 9.1
4.1 SYS 600 9.0
4.0 SP1 SYS 500 8.4.4 SP1
4.0 SYS 500 8.4.4
3.0 SP2 SYS 500 8.4.3 SP4
3.0 SP1 SYS 500 8.4.3 SP2
3.0 SYS 500 8.4.3
2.0 SYS 500 8.4.2
4.5.2. Upgrading COM 500ii revision 1.0
For more information about upgrading revision 1.0, refer to the Communication
Gateway, COM 500
i User’s Guide.
4.6. Updating device drivers
In general the device drivers are backwards compatible within a major revision
number, that is, drivers in 8.4.2 revision is used with Base System Software of
revisions 8.4.1 and 8.4.0.
When updating to MicroSCADA Pro, the driver packages can be installed from the
MicroSCADA Pro software CD or they are included to adapter card package. The
supported versions of the drivers can also be downloaded from the web sites of the
respective manufacturers :
ADLink site: http://www.adlink.com.tw/home.htm
MicroSCADA Pro
Installation and Administration Manual
SYS 600 9.2SYS 600 9.2
1MRS756115