User`s guide

Starting MicroSCADA Pro without preparation for Power Process
Library
If MicroSCADA is wanted to run without Power Process Library do the following
actions after version 9.2 is installed and before starting MicroSCADA.
1. Comment SYS_600 specific part from the file \sc\sys\active\sys_\sys_bascon.
com
2. Comment SYS_600 specific part from the file \sc\Stool\Misc\Apl_Stl.txt
3. Rename file \sc\sa_lib\base\bbone\inst\INDEX5_B1.TXT to e.g. _INDEX5_B1.
TXT
4. Rename file \sc\LIB4\base\bbone\use\PATH4_Z1.TXT to e.g. _PATH4_Z1.TXT
4.4. Communication units
In principle, the process communication unit PC-NET, Modbus Slave and CDC-II
slave can be upgraded to a newer version without changes in the system behavior.
This chapter provides additional information related to the upgrading of IEC 61850
and External OPC Data Access Client.
If the system to be upgraded contains DCP-MUX units, they must be replaced with
PC-NET process communication units. In this situation, it must be checked that all
required protocols are supported by the PC-NET. Furthermore, the configuration
used in DCP-MUX units must be loaded to corresponding PC-NET units with the
system configuration tool or with a SCIL-script. Generally, the same attribute values
for line and station objects can usually be used. Upgrading from DCP-MUX to
PC-NET requires changes in serial port hardware.
The list of the protocol implemented to DCP-MUX and supported by the current
version of PC-NET:
(value refers to line attribute PO)
PO value Protocol
1 ANSI X3.28 Full Duplex or ACP
2 ANSI X3.28 Half Duplex
4 ASCII protocol for printer (or printer
simulating device)
7 RP570 master protocol
9 P214 protocol
12 LCU500
13 ADLP180 Master
14 SPA protocol
15 General ASCII
16 RP570 Slave
17 RCOM (Procontic)
18 Westinghouse F4F
23 ABB Alpha meter protocol
24 General PLC protocol
150
SYS 600 9.2SYS 600 9.2
MicroSCADA Pro
Installation and Administration Manual
1MRS756115