User`s guide

15
*
Modify the base system configuration files to match the actual configuration.
*
Perform administrative tasks: define the startup type, change passwords, share
resources, and so on.
2.1.4. Installing SYS 600
The MicroSCADA Pro installation package contains an installation program, which
creates the directory structure and copies the required files to your hard disk. By
default, the installation program also creates a new program folder named
MicroSCADA Pro Control System SYS 600 icons on the desktop. Any previously
installed MicroSCADA Pro software does not need to be removed before a new
installation. The old files will be overwritten, except for the following ones:
*
SHUTDOWN.CIN (in the folder\sc\prog\exec). Installation preserves the old
version of SHUTDOWN.CIN. The new version is copied into the same directory
and named SHUTDOWN$CIN.
*
PC_NET.CF1, PC_NET.COM, SYS_BASCON.COM, SYS_CONFIG.PAR,
MONITORS.DAT and SYS_NETCON.COM (in the folder \sc\sys\active_\sys_).
Installation preserves the old versions and the new versions are copied into same
directory and named PC_NET$CF1, PC_NET$COM, SYS_BASCON$COM,
SYS_CONFIG$PAR, MONITORS$DAT and SYS_NETCON$COM
respectively.
The applications located under the \sc\apl directory are not touched. The application
TUTOR and WD can be overwritten. The installation program asks whether to do
that or not.
When installing MicroSCADA Pro or some other programs on server
versions of operating systems (2000/2003) use Add New Programs in
the Control Panel and browse the installation package. This will switch
Terminal Services automatically between install and run mode.
A070500
Fig. 2.1.4.-1 Add or Remove Programs window
MicroSCADA Pro installation procedure
To install the MicroSCADA Pro base product software:
MicroSCADA Pro
Installation and Administration Manual
SYS 600 9.2SYS 600 9.2
1MRS756115