User`s guide

The two navigation buttons in the File Set Properties dialog can be used to move
between file sets in the main dialog. The left arrow moves to the previous file set in
the list and the right arrow moves to the next one. If there are unsaved changes in the
File Set Properties dialog, the tool asks whether to save them prior to moving. Saved
changes are propagated to the main dialog; the separate Save command should be
given to save file sets to the parameter file.
3.4.1.5. Viewing execution messages
When the Execution part is activated, and the UI part is open, the Execution part
sends urgent messages to the UI part. All messages sent to UI are also logged, but
not all of the logged messages are sent to UI. When a ‘critical’ or a ‘caution’
message arrives, see File > View Log in Section 3.4.1. Using Disk Management
tool, the UI part opens the Execution Message dialog. The appearance of the dialog
is shown in Fig. 3.4.1.5.-1.
A051569
Fig. 3.4.1.5.-1 The Execution Part dialog
The dialog shows the message status icon, the time stamp, the message text, and the
SCIL status code if any. These messages are not stored permanently. When the main
dialog is closed, they are automatically removed.
The Close button closes the dialog.
The Clear button removes all the messages from the list, but they still remain in the
log file.
The "Open this dialog upon incoming critical and caution messages" check box
allows turning off the dialog pop-up. If this option is turned on, then incoming
‘information’ messages are placed on the list, but the dialog is not automatically
opened. However, the last message sent by the Execution part opens the dialog
regardless of the message status.
3.4.1.6. Viewing log
The Archive dialog handles archives created and updated by the Execution part. It
allows deleting compressed file sets and extracting individual files from archives.
The appearance of the Archive dialog is shown in Fig. 3.4.1.6.-1.
110
SYS 600 9.2SYS 600 9.2
MicroSCADA Pro
Installation and Administration Manual
1MRS756115