User's Manual
MeiG hardware design guide
50
devices or drivers are not available. When testing for emissions from the unintentional radiator, the transmitter shall
be placed in the receive mode or idle mode, if possible. If receive mode only is not possible then, the radio shall be
passive (preferred) and/or active scanning. In these cases, this would need to enable activity on the communication
BUS (i.e., PCIe, SDIO, USB) to ensure the unintentional radiator circuitry is enabled. Testing laboratories may need to
add attenuation or filters depending on the signal strength of any active beacons (if applicable) from the enabled
radio(s). See ANSI C63.4, ANSI C63.10 and ANSI C63.26 for further general testing details.
The product under test is set into a link/association with a partnering WLAN device, as per the normal intended use
of the product. To ease testing, the product under test is set to transmit at a high duty cycle, such as by sending a file
or streaming some media content.
FCC Statment:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s body
and must not transmit simultaneously with any other antenna or transmitter.
L'autre utilisé pour l'émetteur doit être installé pour fournir une distance de séparation d'au moins 20 cm
de toutes les personnes et ne doit pas être colocalisé ou fonctionner conjointement avec une autre
For IC , To meet RF exposure & ERP/ERIP, the maximum net gains of antennas allowed are
10dBi@WCDMA Band II/LTE Band 2 , 7dBi@ WCDMABand IV/ LTE Band 4 , 6.95dBi@
WCDMABand V/LTE Band 5 ,10.00dBi @LTE Band 7, 7.46dBi @ LTE Band 12/LTE Band
17,7.78dBi @ LTE Band 13.