User's Manual

MeiG hardware design guide
48
10. OEM/Integrators Installation Manual
10.1. List of applicable FCC rules
This module has been tested and found to comply with part 22, part 24, part 27 ， part 15.247,part
15.407 requirements for Modular Approval.
10.2. Summarize the specific operational use conditions
This module can be used in POS and other equipment. The input voltage to the module should be nominally 3.5~4.2
VDC ,typical value 3.8VDC and the ambient temperature of the module should not exceed 60℃. SLM756P has four
External fixed rubber antenna with max antenna gain 5dBi . If the antenna needs to be changed, the certification
should be re-applied.
10.3. Limited module procedures
NA
10.4. Trace antenna designs
NA
10.5. RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This
equipment should be installed and operated with minimum distance 20cm between the radiator& your body. If the
device built into a host as a portable usage, the additional RF exposure evaluation may be required as specified by§
2.1093.
10.6. Antennas
Antenna type:
External fixed
rubber antenna
2.4GHz band
Peak Gain
0(dBi)
5.2GHz band
Peak Gain
0(dBi)
5.3GHz band
Peak Gain
0(dBi)
5.5GHz band
Peak Gain
0(dBi)
5.8GHz band
Peak Gain
0(dBi)
Antenna type:
External fixed
rubber antenna
BT Peak Gain
0(dBi)
WCDMA band
2 Peak Gain
10(dBi)
WCDMA band
4 Peak Gain
7(dBi)
WCDMA band
5 Peak Gain
12.92(dBi)
LTE band 2
Peak Gain
10(dBi)
Antenna type:
External fixed
rubber antenna
LTE band 4
Peak Gain
7(dBi)
LTE band 5
Peak Gain
12.92(dBi)
LTE band 7
Peak Gain
10(dBi)
LTE band 12
Peak Gain
13.92(dBi)
LTE band 13
Peak Gain
13.92(dBi)
Antenna type:
LTE band 17