User manual

~ 6 ~
Step 2 – Please turn the rotary arrow clockwise [] from Mode 6 to Mode 1. If you can get
audio/video from the display, you can stay tune at this setting for 1080p and stereo audio. If
you need to get 1080p with 7.1ch audio output, please turn the rotary arrow
counterclockwise [] from Mode 1 to Mode 0. If you cannot get the audio/video out
normally, please go on the next step.
Step 3 – Please turn the rotary arrow counterclockwise [] from Mode 0/1 to Mode 7. Wait a few
seconds until the LED of the RJ-45 connector dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise [] from Mode 7 to Mode 0/1. You should have your
desirable audio/video output. If not, please follow the instruction in Note#1.
3. To learn EDID from the HDMI display, please follow the instruction below:
Step 1 – Please connect the display which you want to read EDID with a HDMI cable to the
transmitter’s HDMI IN and set the rotary arrow at Mode 7 so the TX can learn the EDID
information from the connected display. The LED on the RJ45 connector of TX will dim and
light again in a few seconds, which indicates the EDID learning procedure is complete.
Step 2 – Please turn the rotary arrow clockwise [] from Mode 7 to Mode 0 or Mode 1 for desirable
audio setting and enjoy the experience. DO NOT let the rotary arrow pass by Mode 5 and
Mode 6 which will erase the EDID just learned and restore the default EDID.
Rear Panel — Transmitting Unit CV-57G[Tx]
+5V DC: Connect to 5V DC power supply.
HDMI Signal OUT: Plug in a Cat-5/5e/6 cable that needs to be linked to the RJ-45 connector of the receiving unit
CV-57G[Rx].