User manual

~ 5 ~
Front Panel — Transmitting Unit CV-57G[Tx]
HDMI IN: Connects to a HDMI source with a HDMI male-male cable here
MODE: 0 = [Video] – supports up to HDMI 1.3 output. [Audio] – supports up to 7.1ch output
1 = [Video] – supports up to HDMI 1.3 output. [Audio] – locks to stereo audio output
2 = [Video] – locks to HDMI 1.2 output. [Audio] – supports up to 7.1ch output
3 = [Video] – locks to HDMI 1.2 output. [Audio] – locks to stereo audio output
4 = [Video] – DVI display mode. [Audio] – no audio output
5 = [Safe Mode] – uses default EDID
1
with video supported up to 1080p and stereo audio
6 = [Default Mode] – uses default EDID
2
with video supported up to 1080p and 7.1ch audio
7 = [EDID Learning Mode] – learns EDID
3
from the display
Note for EDID (Extended Display Identification Data) learning
1. If you cannot get the audio/video output from the connected display from the first time setup. Please
follow the instructions below to check if the extender is OK:
Step 1 – Please set the rotary arrow on TX at “Mode 5” for Safe Mode, and wait for the LED of the
RJ-45 connector blinks for a couple seconds.
Step 2 – Please turn the rotary arrow counterclockwise [] from Mode 5 to Mode 3. If you can get
audio/video from the display, you can stay tune at this setting for 720p or 1080i and stereo
audio. If you need to get 720p/1080i with 7.1ch audio output, please turn the rotary arrow
counterclockwise [] from Mode 3 to Mode 2. For better audio/video output, please check
Note#2. If you still cannot get the audio/video out normally, please go on the next step.
Step 3 – Please turn the rotary arrow counterclockwise [] from Mode 3 to Mode 7. Wait a few
seconds until the LED of the RJ-45 connector dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise [] from Mode 7 to Mode 1. You should have normal
audio/video output. If not, please contact technical support.
2. For desirable 1080p video output, please follow the instructions below:
Step 1 – Please set the rotary arrow on TX at “Mode 6” for Default Mode, and wait for the LED of the
RJ-45 connector blinks for a couple seconds.
Panel Description