Use Instructions

材质：80g书纸，单黑双面印刷
尺寸：210*90MM
正面
反面
Specification:
● Item No.:MSH-WI-001
● Model name: Apple watch charging cable
● Material: PVC+Aluminum shell
● Input: 5V/ 1A
● Output: 5V/ 1A
● Length: 3.3 feet(1meter)
● Net weight: 38.7g
● Working environment: -10℃~+50℃
PHOTOGRAPH OF THE PRODUCT
PVC
Wireless output
USB input
Made for:
● Apple Watch Series 1: Apple Watch, Apple
Watch Sport, Apple Watch Edition
● Apple Watch Series 2: Apple Watch, Apple
Watch Nike+, Apple Watch Hermès, Apple
Watch Edition
● Apple Watch Series 3: Apple Watch, Apple
Watch Nike+, Apple Watch Hermès, Apple
Watch Edition
(Both 38mm and 42mm Version)
Use Instructions:
● Install the Apple Watch magnetic charging
cable into your dock.
● Connect the USB connector to 5V USB
power.
● Place the Apple Watch on the magnetic
module surface while charging, kindly take
off case before that.
● Battery icon displays on the screen
indicating charging status
Please Note:
Our Magnetic Charging Cable is bigger
than Apple Original, can't Fit in Apple Dock
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.The
device has been evaluated to meet general RF exposure requireme
nt.
The device can be used in portable exposure condition without r
estriction.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. During the operation of device a distance of
15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
FCC ID:2ATWUPWR10440A