Installation Instructions

FRONT BACK

Model No.:CP022

Type C Input: 9V 2A

USB-1 Output: 5V 0.5A

USB-2 Output: 5V 0.5A

Wireless Output: 5W/7.5W/10W(Max)

FCC ID: 2ATWUCP022

Made in China

FCC Warning

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

approved by the party responsible for compliance could void the

user's authority to operate the equipment. This equipment has

been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure

requirement. The device can be used in portable exposure condition

without restriction.

All in one wireless charger station