Safety Data Sheets (SDS)

Ultimate Insane Shine Foam G2104 [G210419]
09/04/20
Page 4 of
11
Ingredient
C.A.S. No.
Agency
Limit type
Additional Comments
BUTANE
106-97-8
ACGIH
STEL:1000 ppm
Natural gas
106-97-8
ACGIH
Limit value not established:
simple asphyxiant
PROPANE
74-98-6
ACGIH
Limit value not established:
simple asphyxiant
PROPANE
74-98-6
OSHA
TWA:1800 mg/m3(1000 ppm)
follow safety precautions on the solvent label and SDS. Seal the container. Dispose of collected material as soon as
possible in accordance with applicable local/regional/national/international regulations.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition
source. Do not pierce or burn, even after use. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on
skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid contact
with oxidizing agents (eg. chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Protect from sunlight. Do not expose to temperatures exceeding 50C/122F. Store away
from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
ACGIH : American Conference of Governmental Industrial Hygienists
AIHA : American Industrial Hygiene Association
CMRG : Chemical Manufacturer's Recommended Guidelines
OSHA : United States Department of Labor - Occupational Safety and Health Administration
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Full Face Shield
Indirect Vented Goggles
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity.